Check My CCTV
MIB Smartech technical support
We diagnose recurring trips, burnt sockets, lighting faults, wiring problems and earthing concerns using suitable electrical test instruments before recommending corrective work.
Request Electrical DiagnosisCommercial implementation & support
Professional electrical troubleshooting, testing and corrective work based on measured findings—not guesswork.
Every site is assessed for its operational needs, existing infrastructure and maintainability. We explain the scope clearly before installation, repair, upgrade or ongoing support.
Electrical fault finding
Electrical faults can begin with a small symptom: one socket becomes hot, a light flickers, a breaker trips occasionally or a burning smell appears only when equipment is operating.
Resetting the breaker or replacing a component without finding the cause may allow the fault to return. MIB Smartech checks the circuit systematically, records relevant readings and identifies the most likely fault before recommending repair or replacement.
Common electrical issues
These symptoms can have more than one cause. The affected circuit should be inspected and tested before corrective work is confirmed.
An MCB, RCCB or main protective device trips again after being reset.
Possible causesThe socket face, plug or surrounding area shows heat damage, discolouration or a burning smell.
Possible causesA lighting switch causes part or all of the property to lose power.
Possible causesLighting brightness changes, flickers or becomes unstable during normal use.
Possible causesA socket, isolator or switch becomes warmer than expected during operation.
Possible causesA person feels a mild shock when touching an appliance, metal body or fitting.
Possible causesThe protective device trips immediately or will not remain in the ON position.
Possible causesUnusual noise or odour appears at a distribution board, socket, switch or fitting.
Possible causesMeasured diagnosis
A visible burn mark may show where the damage appeared, but not always why it happened. Testing helps us trace the fault across the supply, protective device, circuit, connection point and connected load.
Diagnostic equipment
The exact instruments used depend on the symptom, circuit condition and safe access available during the visit.
Measures load current without disconnecting the conductor. Depending on the instrument and test method, its meter functions can also be used to verify voltage and other electrical values.
Checks whether a de-energised conductor or connection has a continuous path and helps identify open circuits, incorrect connections or suspected shorts.
Applies a controlled test voltage to assess insulation resistance between conductors and earth, helping identify deterioration, moisture or leakage risk.
Measures the resistance of the earthing or grounding system using the suitable test method, helping determine whether the protective earth path requires attention.
Verifies values such as AC/DC voltage, resistance and continuity during systematic fault isolation.
Where applicable, checks socket wiring conditions and protective-device operation as part of the wider diagnosis.
Troubleshooting scope
We support homes, offices, shops and selected commercial premises across Selangor, Kuala Lumpur and the Klang Valley.
Check protective devices, circuit loading, termination condition and relevant fault indications.
Trace loss of supply, overheating, loose connections, damaged accessories and wiring concerns.
Investigate flickering, repeated failure, partial blackout and faults involving switches, fittings or drivers.
Assess continuity, insulation condition and protective earthing where the site condition requires testing.
Safety first
If there is smoke, active sparking, a strong burning smell, exposed live parts or a shock risk, stop using the affected equipment, keep people away and isolate the supply only if it is safe to do so. Arrange an urgent inspection by a competent electrical person.